The FUE technique of follicular unit extraction is the least
invasive techniques of best hair transplant in Delhi. This
procedure leaves no linear scar in the donor area because it does not use
scalpel or sutures. FUE consists in collecting the follicular units one by
one in the donor zone using circular micro-punch of the diameter corresponding
to the follicular units of the patient.
FUE -
Follicular Unit Extraction procedure - the craze triggered by a transplant
Scarring-free hair is very important because many men treated for male hair
loss do not wish any traces of a hair transplant in Noida.
Why the FUE?
Today, the main benefit that patients see in FUE is the
absence of a linear scar due to FUT in the donor area. But when the FUE hair transplant in Delhi
was developed, the first motivation of the hair transplant surgeon in Delhi
was not the absence of scar but beautiful and well enlargement of the sampling
area.
The benefits of FUE:
limiting the donor area and new sampling areas
Previously at the arrival of the FUE, the hair transplant doctor in Delhi
faced the problem of patients who had already undergone one or more
interventions and whose donor area by FUT had been exhausted. These
patients no longer had a sufficient donor area to cover the needs of the
receiving area. FUE widens the donor area by 30% and 50% compared to the FUT. By
allowing the exploitation of the temporal zones and the high and low zones of
the occipital region, the donor zone is found enlarged and thus increases the
number of possible hair transplant in
Moradabad.
The benefits of FUE hair transplant in Delhi:
short cut and no linear scar
The scar of the strip test: Some patients
do not want any traces of the procedure and in particular the scar after taking
the strip. FUE leaves almost no trace visible to the naked eye. Patients
can find their hair and the freedom to wear their hair as they wish.
The so-called FUE graft procedure meets these criteria: the
absence of a recognizable linear scar, and the widening of the sampling area.
Today there are two distinct types of direct extractions,
FUE and FIT (Follicular Isolation Transplantation), which are differentiated by
the number of gestures in the follicle isolation stage but both are linear
scar-free procedures. and allowing a large number of grafts.
The steps of the FUE
procedure
5 operative steps punctuate the FUE graft
procedure. Each step is equally important to each other and influences the
outcome of the transplant.
Step 1: Mowing and
preparation for the procedure
For FUE hair from the donor area is usually shorn. It
is impossible to remove a follicle if the hair is more than 1mm.
However, a mowing "total" can sometimes be avoided
depending on the case. This is called FUE "Patchy" or
"Unshaven". Normal FUE requires total mowing. Mowing is
done without a hoof. The ultra-short cut is still quickly forgotten because
15 days after the operation, the hair has already pushed back 0.5 cm
Step 2: isolate the
hair follicles
The follicles are then selected directly on the scalp of the
patient, the hair is isolated with a titanium punch with a diameter ranging
from 0.7 to 1.0 mm. This step is one of the advantages of the FUE, we can
then select each graft and therefore favour grafts of 1, 2, 3 hairs according
to the needs of the recipient area. This is the so-called " Cherry
Picking " stage - we select the best transplants!
To isolate the grafts, the punch drops 3 to 4 mm into the
skin along the hair and follicle. This is the only step that requires the
FUE punch. The grafts then isolated and dissociated from the epidermis and
the dermis. But this one remains in the skin for the moment. They are
not yet extracted.
The punch isolates the follicles on the scalp
Step 3: Extract the
hair follicles "Cherry Picking"
Using micro-forceps, either a micro-forcep or a
"mosquito" forceps, the selected follicles are extracted one by
one. Each graft is then deposited in physiological saline and / or in a
mixture of PRP and physiological saline. The grafts are then sorted and
checked and prepared for implantation. The extraction procedure is then
complete. One can begin the procedure of incisions and implantation which
is the same in FUE or FUT.
Step 4: incisions in
the recipient area
Using blades cut to the size of the follicular units, the
practitioner draws the new hair using micro-incisions in the area to be
grafted. The slides are cut and prepared for each patient. They are for
single use.
It is at this stage that factors deciding the outcome of the
hair transplant in South Delhi. These
factors are:
- The
angle of the hair
- the
distribution
- The
density
The incision stage determines the design of your hair
transplant.
Step 5: Placement of
the grafts in the incisions
With each graft of 1,2 and 3 hairs previously separated and
sorted, they are now inserted into each incision. This step is often
performed by several hands because up to 3 people can work at the same time and
insert the grafts on the patient's scalp.
The grafts will now re-oxygenate and then reconnect to the
patient's vasculature.
The FUE operation is finished. Then begins the waiting
for the regrowth of the transplant. Patients benefit from their outcome 7
to 8 months later, but at least 12 months are needed for complete regrowth, and
up to 15 to 18 months for thickening hair.
After the FUE
transplant: the postoperative
After about ten days, the traces of extraction fade
and the donor zone resumes its normal appearance after 15 to 20 days.
If the patient does not wish to mow the hair, then the
procedure must be performed in FUE called "patchy" or "without
shaving".
It usually takes 15 days for the rash on the receiving area
to fade.
About 1 month to 2 months after the FUE operation, all
implanted hair falls back. This is a normal process. 12 months will
be required for complete regrowth. Treatments can be used to speed up the
process.
The size of FUE
punches
FUE punches have evolved a lot since the beginning of this
procedure. At first, the first FUE grafters used punches used for
biopsies. Quickly, the punches evolved to versions exclusively designed
for FUE varying sizes and shapes. Today the punches are machined almost
entirely in Titanium because of the biocompatible and allergenic property of
this material.
Punch sizes vary mainly from 0.7 millimetres to 1 millimetre. The
extremely small size of the punches helps to make the FUE almost invisible and
without visible scars. Of course, the size of the FUE punches is not the
only factor to participate in more or less visible traces left by the
levy. The quality of the punch blade - more or less sharpened - and the
genetic heritage of the patient are factors of the same importance as the size
of the punch.
No comments:
Post a Comment